Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 203)

Running a Program
Chapter 7
7-27
To perform a program restore operation after automatic program execution
has been interrupted follow these steps:
1. Press the
{PRGRAM MANAGE}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
Important: DO NOT SELECT A PROGRAM AS AN ACTIVE
PROGRAM. Do not disable the currently active program (if any). If a
program is reselected as active or disabled by the operator the program
restore feature is canceled.
2. Press the
{RESTRT PRGRAM}
softkey. The control automatically
re-selects the interrupted program if it was disabled by the control
when power was lost.
REFORM
MEMORY
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. To automatically search for the block in the current program that was
interrupted press the
{EXEC}
softkey.
The control will locate an @ symbol to the left of the block
immediately before the block that automatic execution was
interrupted at.
If this is not the block to begin execution from, press the
{QUIT}
softkey. The program restore feature will be aborted.