Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 694)

Paramacros
Chapter 28
28-20
#3006
Program Stop With Message
Use this parameter to cause a cycle stop operation and display a message
on line 1 of the CRT. Any block that assigns a new value to the parameter
3006 will result in a cycle stop. Any decimal value may be assigned to this
parameter the value of which is not used.
When the control executes this block, a cycle stop is performed and the
message “SEE (MESSAGE) IN PART PROGRAM BLOCK” is displayed
on line 1 of the CRT. This is intended to point out to the operator an
important comment in a program block (see chapter 10 on comment
blocks). This parameter is a write-only.
For example, programming:
#3006=.1 (Install Tool Number 6);
will cause program execution to stop at the beginning of this block and the
message display the message telling the operator to read the comment in
the block.
#3007
Mirror Image
This parameter is a read-only. It generates an integer that represents, in
binary, what axes are mirrored. For example, if the value of this parameter
was 3, the binary equivalent for this is 00000011. The first digit of this
binary equivalent (reading right to left) corresponds to axis 1, the second is
axis 2, the third is axis 3, etc., up to the number of axes configured in your
system. When a zero is in the binary location for an axis, it indicates that
the axis is not mirrored. If a 1 is in that axis location, that axis is mirrored.
For example, if the parameter #3007 is the integer 11 (binary 00001011), it
indicates axes 1, 2, and 4 are mirrored and axes 3, 5, and 6 are not
mirrored.
0 0 0 0 1 0 1 1
6 5 4 3 2
1
*Axis Number
Listed Below
7
8
Where:
0 indicates axis is not mirrored
1 indicates axis is mirrored