Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 691)

Paramacros
Chapter 28
28-17
Table 28.D (continued)
System Parameters
Parameter # System Parameter Page
5731 to 5743 Home Marker Distance 28-31
5751 to 5763 Home Marker Tolerance 28-31
1 These parameters may only have their value received (read-only)
2 These parameters may only have their value changed (write-only)
#2001 to 9499
Tool Offset Tables
These parameters may be changed or simply read through programming.
The values for these parameters are received or entered into the tool offset
tables for geometry and wear (discussed in chapter 3). NO TAG gives the
parameter numbers associated with each table value.
Table 28.E
Tool Offset Table Parameters
Offset
Number
Parameter # for
Geometry Table
Parameter # for Wear
Table
Tool Length
(Axis 1)
1 to 99 #2701 to 2799 #2001 to 2099
Tool Length
(Axis 2)
1 to 99 #2801 to 2899 #2101 to 2199
Tool Length
(Axis 3)
1 to 99 #8501 to 8599 #8101 to 8199
Tool Length
(Axis 4)
1 to 99 #8601 to 8699 #8201 to 8299
Tool Length
(Axis 5)
1 to 99 #8701 to 8799 #8301 to 8399
Tool Length
(Axis 6)
1 to 99 #8801 to 8899 #8401 to 8499
Tool Radius 1 to 99 #2901 to 2999 #2201 to 2299
Tool
Orientation
1 to 99 #2301 to 2399 N/A
#3000
Program Stop With Message (PAL)
Use this parameter to cause a cycle stop operation and display a message
on line 1 of the CRT. Any block that assigns any non-zero value to
parameter 3000 will result in a cycle stop. The actual value assigned to
parameter 3000 is not used. Parameter 3000 is a write-only parameter.