Rockwell Automation 8520 9/Series CNC Lathe User Manual
Page 298
Introduction to Programming
Chapter 10
10-30
(1) Program Stop (M00)
When you execute M00, execution stops after the block containing the
M00 is executed. At this time, the CRT displays the “PROG STOP”
message. To restart the operation, press the
(2) Optional Program Stop (M01)
The optional program stop function has the same effect as the program stop
function, except that it is controlled by an external switch. When the
OPTIONAL PROGRAM STOP switch is placed in the OFF position, the
M01 code in the program is ignored. This switch and the appropriate PAL
programming are the responsibility of your system installer.
(3) End of Program (M02)
If you execute a program from control memory, the M02 code acts the
same as an M30. Program execution stops and the control enters the cycle
stop state. The program is reset to the first block and a
begins part program execution over again. See M99 for auto cycle start.
If you execute a program from an external device (such as a tape reader),
when M02 is executed, program execution stops and the control enters the
cycle stop state. The M02 does not cause a tape rewind. The tape reader
must be rewound using some other method before program execution can
resume.
With some machines, the M02 code can also result in a spindle and coolant
supply stop. For details, refer to the instruction manual prepared by your
system installer.
(4) End of Program, Tape Rewind (M30)
If you execute a program from control memory, the M30 code acts the
same as an M02. Program execution stops and the control enters the cycle
stop state. The program is reset to the first block and a
begins part program execution again. See M99 for auto cycle start.
If you execute a program from an external device (such as a tape reader),
when M30 is executed, program execution stops and the tape is
automatically rewound to the beginning of the program just executed.
After the tape rewinds, the control enters the cycle stop state. A START> begins part program execution again. See M99. With some machines, the M30 code can also result in a spindle and coolant supply stop. For details, refer to the instruction manual prepared by your system installer.