Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 240)

Displays and Graphics
Chapter 8
8-30
4. Set Auto Size. Use the up and down cursor keys to select the
parameter. Set auto size by pressing the left or right cursor keys. The
value for the selected parameter changes each time you press the left
or right cursor key.
If you turn this parameter “ON”, the control re-sizes the graphics
screen to the size of the programmed part. To use this feature, turn
this parameter “ON”, then run the part program. When the part
program is finished, the control re-sizes the graphics screen then turns
this parameter “OFF.”
5. Set Grid Lines. Use the up and down cursor keys to select the
parameter. Set it by pressing the left or right cursor keys. The data
for the selected parameter changes each time you press the left or
right cursor key.
When this
parameter is:
The control:
On overlays the graphics screen with grid lines. These grid lines are
solid lines drawn at the axis coordinate tick marks.
Off does not display lines.
6. Set Overtravel Zone Lines. Use the up and down cursors to select
the parameter. Set it by pressing the left or right cursor keys. The
data for the selected parameter changes each time you press the left or
right cursor key.
When this
parameter is:
The control:
On draws overtravel/zone lines on the graphics screen. These
overtravel/zone lines correspond to the active software overtravel
limits and the programmable zone limits. The software overtravel
limits are specified in AMP by your system installer. The
programmable zone limits must be programmed by the operator. The
software overtravel and programmable zone lines are dotted lines.
Off does not display lines.