Rainbow Electronics AT91CAP9S250A - Manual (Page 977)

977
6264A–CAP–21-May-07
AT91CAP9S500A/AT91CAP9S250A
Figure 47-6. DDRSDRC Timings
The timings of the DDR SDRAM controller support the use of LPDDR200 Double Data Rate
Mobile SDRAM in MAX and STH corners.
Notes: 1. Control/Address is the set of following signals: A0-A9, A11-A13, SDCKE, SDCS, RAS, CAS, SDA10, BAx and SDWE.
2. Data out, DQS refer to D0-D7, DQS0 or to D8-D15, DQS1.
3. DQM refers to DQM0 or DQM1.
SDCK
Control, Addresses
SDCKN
DDR
1
DDR
2
DDR
6
DDR
7
Data in
DDR
4
DDR
5
DDR
4
DDR
5
Data out, DQM
DDR
3
DQS out
DQS in
Table 47-35. LPDDR200 Characteristics
Parameter Symbol Min Max Units
SDCK/SDCKN Clock Period t
CK
10 ns
SDCK/SDCKN Clock low or high level t
CL
,t
CH
0.45 0.55 t
CK
Control/Address In Setup (1) t
IS
1.5 ns
Control/Address In Hold (1) CH t
IH
1.5 ns
DQS output access time from SDCK/SDCKN t
DQSCK
2 7.0 ns
DQS (2) - Data Out Skew t
DQSQ
0.7 ns
Data out output hold time from DQS (2) t
QH
min(t
CL
,t
CH
)-1.0 ns
Data in and DQM (3) Setup before DQS edge t
DS
1.1 ns
Data in and DQM (3) hold after DQS edge t
DH
1.1 ns