Avago Technologies LSI53C1000R - Manual (Page 382)

IX-10 Index
capabilities 4-18
control/status 4-19
state
D0 2-62
D1 2-62
D2 2-63
D3 2-63
state (PWS[1:0]) 4-20
prefetch
enable (PFEN) 4-66
flush 2-32
flush (PFF) 4-66
SCRIPTS instructions 2-31
protocol options 2-25
pull-ups, internal, conditions 3-4
R
RAM, See also SCRIPTS RAM 2-20
RBIAS 3-17
read
line 2-11 , 2-12 , 2-13
line function 2-8
modify-write cycles 5-24
multiple 2-9 , 2-11 , 2-12 , 2-13
multiple with read line enabled 2-9
write instructions 5-23
write system memory from a SCRIPT 5-35
read/write
instructions 5-23 , 5-25
system memory from a SCRIPT 5-35
receive rate calculation 2-43
received
master abort (from master) (RMA) 4-5
target abort (from master) (RTA) 4-5
register
address 5-40
address - A[6:0] 5-24
interrupt 2-46
map
PCI A-1
SCSI A-3
relative 5-20
relative addressing mode 5-18 , 5-30
remaining byte count (RBC) 4-116
REQ/ 3-8
req/ack offset 2-24
REQ64/ 3-7
request 3-8
request 64 3-7
reselect 2-18
during reselection 2-41
instruction 5-15
reselected (RSL) 4-70 , 4-74
reserved command 2-6
reset 3-5
input 6-12
SCSI offset (ROF) 4-86
response ID one (RESPID1) 4-83
response ID zero (RESPID0) 4-82
return instruction 5-28
revision ID register 4-6
(RID[7:0]) 4-6
rise and fall time test condition 6-8
ROM 2-58
flash and memory interface signals 3-14
routing interrupts 2-53
routing, RAID ready 2-53
RST/ 3-5
S
SACK 2-51
SACs 2-21
scan mode 3-15
SCAN_MODE 3-15
SCANEN 3-15
SCF divisor values 2-42
SCLK 3-10
quadrupler enable (QEN) 4-85
quadrupler select (QSEL) 4-85
scratch
byte register (SBR) 4-66
register A (SCRATCHA) 4-62 , 4-125
register B (SCRATCHB) 4-96 , 4-127
registers C–R (SCRATCHC–SCRATCHR) 4-97
script fetch selector (SFS) 4-98 , 4-129
SCRIPTS 2-57
64-bit addressing 2-21
block move
index mode 0 5-8
index mode 1 5-8
indirect addressing 5-5
instruction type 5-5
opcode 5-10
SCSI phase 5-12
start address 5-13 , 5-14
table indirect addressing 5-6
transfer counter 5-13
block move instructions 5-4
call instruction 5-28
chained block moves 2-55
clear instruction 5-16
disconnect instruction 5-15
I/O
encoded SCSI destination ID 5-21