Avago Technologies LSI53C1000R - Manual (Page 177)

SCSI Registers 4-65
Version 2.2 Copyright © 2000–2003 by LSI Logic Corporation. All rights reserved.
Register: 0x39
DMA Interrupt Enable (DIEN)
Read/Write
This register contains the interrupt mask bits corresponding to the
interrupting conditions described in the
DMA Status (DSTAT) register. An
interrupt is masked by clearing the appropriate mask bit. Masking an
interrupt prevents INTA/ from being asserted for the corresponding
interrupt, but the status bit is still set in the
DMA Status (DSTAT) register.
Masking an interrupt does not prevent setting the Interrupt Status Zero
(ISTAT0) DIP. All DMA interrupts are considered fatal. Therefore,
SCRIPTS halts when this condition occurs, whether or not the interrupt is
masked. Setting a mask bit enables the assertion of INTA/ for the
corresponding interrupt. A masked nonfatal interrupt does not prevent
unmasked or fatal interrupts from getting through; interrupt stacking
begins when either the Interrupt Status Zero (ISTAT0) SIP or DIP bit is set.
The INTA/ output is latched. When asserted, it remains asserted until the
interrupt is cleared by reading the appropriate status register. Masking
an interrupt after the INTA/ output is asserted does not cause
deassertion of INTA/. For more information on interrupts, refer to
Chapter 2, “Functional Description.”
R Reserved 7
MDPE Master Data Parity Error 6
BF Bus Fault 5
ABRT Aborted 4
SSI Single Step Interrupt 3
SIR SCRIPTS Interrupt Instruction Received 2
R Reserved 1
IID Illegal Instruction Detected 0
7 6 5 4 3 2 1 0
R MDPE BF ABRT SSI SIR R IID
x 0 0 0 0 0 x 0