Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 148)

Chapter 7
Creating and Editing a Program File
7–36
The following is a list of the search commands available on the HHT:
Function Key Description
[ F1 ], CURSOR–INSTRUCTION
Searches for all instructions that are the same type as the
instruction that the cursor is positioned on.
[ F2 ], CURSOR–OPERAND
Searches for every instruction that contains the address
associated with the instruction that the cursor is positioned
on.
[ F3 ], NEW–INSTRUCTION
Displays the ladder editing menu of the available instruction
symbols and/or mnemonics.
[ F4 ], UP/DOWN
Toggles the search direction within the program.
When UP is displayed, the search starts at the cursor
location and continues down to the end of the program,
then wraps around to the start of the program.
When DOWN is displayed, the search starts at the cursor
location and continues up to the start of the program, then
wraps around to the end of the program.
[F5 ], FORCE Searches for all forces installed in a program.
Additionally, a search rung feature is available from either the offline, edit
file display or the online, monitor file display, using the
[RUNG] key located
on the keypad.