Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 107)

Chapter 6
Creating a Program
6–9
2. Press [F1] , CHG_NAM. The following display appears:
––––––– Change Program/File Name –––––––
File Name:
Program Name: DEFAULT
F1 F2 F3 F4 F5
OFL
PROGRAM FILE
3. Press [F2] , PROGRAM.
The following display appears:
––––––– Change Program/File Name –––––––
File Name:
Program Name: DEFAULT
ENTER NAME: DEFAULT
F1 F2 F3 F4 F5
OFL
4. Name your program 1000 . Type 1000, then press [SPACE] , then
[ENTER] . The program name is entered and you are returned to the
previous display.
––––––– Change Program/File Name –––––––
File Name:
Program Name: 1000
F1 F2 F3 F4 F5
OFL
PROGRAM FILE
Important: If you forget to press the [SPACE] key, the program name is now
1000ULT . Whenever you create a new program name or change
the name; if the previous name consists of more characters than
the new one, the
[SPACE] key must be used to clear the
additional characters. To correct the name, repeat the above
procedure.
Naming Your Main Program File
Unlike the ladder program name, it is not required that you name the main
program file. However, a main program file name is helpful, especially if
there are multiple program files, such as a main program file (always file 2)
and one or more subroutine files (files 3 through 255).