Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 108)

Chapter 6
Creating a Program
6–10
1. Continuing from the change name display, press [F4] , FILE. This
display appears:
––––––– Change Program/File Name –––––––
File Name:
Program Name: 1000
ENTER NAME:
F1 F2 F3 F4 F5
OFL
2. Name the main program file 222. Type 222 , then press [ENTER] . The
main program file name is entered and you are returned to the previous
menu.
The same restrictions apply to the characters for the main program file
name as to ladder program names. Also, using the
[SPACE] key may be
necessary if you are re–naming the main program file.
3. Exit this menu level by pressing [ESC] . The program maintenance
display appears:
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 222 Ladder *
F1 F2 F3 F4 F5
CHG_NAM CRT_FIL EDT_FIL
OFL
DEL_FIL > MEM_MAP
Program Name Main Program
File Name
File Size
The program directory now shows the name of the program, which is
1000 and the name of the main program file, which is 222. The display
also shows the file sizes. At this point, asterisks (*) are displayed
because no ladder programs are entered.
Password protection prevents access to a program file and prevents changes
from being made to the program. Each program may contain two passwords;
the password and the master password. The master password overrides the
password. This function is available for the offline HHT program, from the
utility menu display and for the online processor program, from the attach
display. You can only use numeric–based passwords.
Passwords