Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 114)

Chapter 7
Creating and Editing a Program File
7–2
3. To create subroutine program file 3, press [3] then [ENTER] . File 3 is
created and the following display appears showing subroutine file 3 as a
ladder file.
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 222 Ladder *
3 Ladder *
F1 F2 F3 F4 F5
CHG_NAM CRT_FIL EDT_FIL
OFL
DEL_FIL > MEM_MAP
You may not name any of the subroutine program files using the HHT.
Subroutine program files may be named on an APS terminal. These
programs may be uploaded to, and displayed on the HHT.
Creating a Subroutine Program File using a Non–Consecutive File
Number
In this example create subroutine program file 6.
1. From the above display press [F2] , CRT_FIL.
2. Press [6] , then [ENTER] . File 6 is created, but the display does not
change.
3. Press the [
↓
] key 3 times to view file 6.
File Name: 222 Prog Name:1000
File Name Type Size(Instr)
3 Ladder *
4 Undefined *
5 Undefined *
6 Ladder *
F1 F2 F3 F4 F5
CHG_NAM CRT_FIL EDT_FIL
OFL
DEL_FIL > MEM_MAP
These files are listed, but
not created.
Notice that files 4 and 5 are listed as Undefined and file 6, the file you
created, is listed as Ladder . Although files 4 and 5 are not created, they
are still displayed. You may create the files at a later time by repeating
the above procedure.