Rockwell Automation 1747-PT1, D1747NP002 Hand-Held Terminal - Manual (Page 129)

Chapter 7
Creating and Editing a Program File
7–17
4. Press [F3] , MOD_INST, then [ZOOM] .
The following display appears with the cursor on the first character of the
instruction address, on the prompt line:
ZOOM on XIC
NAME:
EXAMINE IF CLOSED
BIT ADDR:I1:1.0/2
ENTER BIT ADDR: I1:1.0/2
F1 F2 F3 F4 F5
] [ 2.0.0.0.2
ACCEPT EDT_DAT
5. To change the address:
•
either write over the 2 with a 1 by pressing the [
→
] key seven times
to position the cursor over the 2 , then press [1] , then [ENTER]
•
or enter the entire new address and then press [ENTER]
Important: When using the second method, you must press the [SHIFT]
key for the file type (I, O, B...). Also, if the previous address
contains more characters than the new one, you must use the
[SPACE] and the [
→
] keys to clear each remaining character
before pressing [ENTER] .
When the new address is displayed on the prompt line:
ZOOM on XIC
NAME:
EXAMINE IF CLOSED
BIT ADDR: I1:1.0/1
ENTER BIT ADDR: I1:1.0/1
F1 F2 F3 F4 F5
] [ 2.0.0.0.2
ACCEPT EDT_DAT
6. Press [F5] , ACCEPT. The display returns to the ladder display, and the
address is changed, as indicated in the upper left corner.
I I ] [
2.0.0.0.2
OFL
] [ ( )
] [
] [ ( )
<
END
>
XIC:I1:1.0/1 NO FORCE
F1 F2 F3 F4 F5
BIT TMR/CNT I/O_MSG COMPARE CPT/MTH
7. To accept the new address, press [ESC] once to display the proper menu,
then press [F5] , ACP_RNG.
8. Save the changes.