Lenze 8400 HighLine - Manual (Page 833)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
833
15 Parameter reference
15.2 Parameter list | C00142
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00142
C00144
Parameter | Name:
C00142 | Auto-start option
Data type: UNSIGNED_8
Index: 24433
d
= 5F71
h
Starting performance of the controller after mains connection, undervoltage, loading of the Lenze setting as well as
a reset of "Trouble" or "Fault" can be parameterised individually.
 Automatic restart after mains connection/fault...
Setting range (min. hex value | max. hex value) Lenze setting
0x00 0xFF 0x19 (decimal: 25)
Value is bit-coded: ( = bit set) Info
Bit 0  Inhibit at power-on
Bit 1  Inhibit at trouble
Bit 2  Inhibit at fault
Bit 3  Inhibit at undervoltage
Bit 4  Inhibit at Lenze setting
From version 06.00.00
Bit 5  Reserved
Bit 6  Reserved
Bit 7  Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00144 | Switching freq. reduct. (Temp.)
Data type: UNSIGNED_8
Index: 24431
d
= 5F6F
h
Activation of the automatic switching frequency reduction if the temperature is too high
Selection list
(Lenze setting printed in bold) Info
0 Off Automatic switching frequency reduction deactivated
1 On Automatic switching frequency reduction activated
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1