Lenze 8400 HighLine - Manual (Page 533)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
533
8 Basic drive functions (MCK)
8.4 Basic settings
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Re-activation after acknowledging the error
When the error has been acknowledged and the limit switch is still active, the following action is
required for a renewed activation of the monitoring depending on the operating mode:
Operating mode Action for (re) activation
Speed follower Limit switch is activated and setpoint in direction of the activated limit switch is pending
Note: If the setpoint e.g. is specified via an analog potentiometer, potentiometer noise can
mean an unintentional setpoint causing the error to be set again.
Homing Limit switch is activated and bHomStartStop = TRUE
Manual jog Limit switch is activated and manual jog in direction of the activated limit switch
Positioning Limit switch is activated and setpoint command has been transmitted
Stop Setting of the operating mode
Position follower Limit switch is activated and setpoint in direction of the activated limit switch is pending