Lenze 8400 HighLine - Manual (Page 1336)

17 Function library
17.1 Function blocks
1336
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Outputs
Parameter
Identifier
Data type
Value/meaning
bSync
BOOL
Status signal "Drive is running synchronously"
TRUE The drive is running synchronously, the speed input id directly
applied to the speed output.
nOut_v
INT
Speed/angle setpoint
• Scaling: 16384 ≡ 15000 rpm
bFail
BOOL
Status signal "Angular difference exceeded"
TRUE The angular difference set in C01078/1 has been exceeded.
Parameter Possible settings Info
C01076/1 0.000 s 999.900 Acceleration and deceleration time
• Relating to the reference speed
(constant acceleration and
deceleration) set in C00011 .
• It is a maximum value which
limits the acceleration of the
ramp function generator.
• Lenze setting: 1.000 s
C01076/2 0.000 s 999.900 Deceleration time for quick stop of
the slave drive
• Relating to the reference speed
(constant acceleration and
deceleration) set in C00011 .
• It is a maximum value which
limits the deceleration of the
ramp function generator.
• Lenze setting: 0.000 s
C01077/1 1 rpm 15000 Max. speed-up
• Lenze setting: 3000 rpm
C01078/1 10 Incr. 2000000000 Following error limit
• Scaling: A revolution is displayed
with 65536 increments or steps.
• Lenze setting: 2000000000 incr.
C01079/1 0 Incr. 65535 Synchronisation window (position)
• If the difference between the
master and the slave is lower than
the synchronisation window, the
bSync status signal is set to TRUE.
• Lenze setting: 100 incr.
C01080/1 -2147483647 Incr. 2147483647 Offset
• Angular offset for the internal
actual position of the FB
• Scaling: A revolution is displayed
with 65536 increments or steps.
• Lenze setting: 0 incr.