Lenze 8400 HighLine - Manual (Page 21)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
21
1 About this documentation
1.1 Document history
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
Target group
This documentation addresses to all persons who would like to parameterise, configure and
diagnose the 8400 HighLine with the Lenze engineering software »Engineer« and the X400 keypad.
Validity
The information in this documentation are valid for the following standard devices:
Screenshots/application examples
All screenshots provided in this documentation are application examples. Depending on the
software version of the controller and the version of the installed »Engineer« software, the
screenshots in this documentation may differ from the representation in the »Engineer«.

Tip!
Information and tools for Lenze products are provided in the download area at
http://www.lenze.com  Download
1.1 Document history

Danger!
The controller is a source of danger which may lead to death or severe injury of persons.
To protect yourself and others against these dangers, observe the safety instructions
before switching on the controller.
Please read the safety instructions provided in the 8400 mounting instructions and in
the 8400 hardware manual. Both documents are supplied with the controller.
Product series Type designation from software version
8400 HighLine C E84AVHCxxxxx 01.00
Version Description
10.0 06/2014 TD05 Extended by new functions for 8400 HighLine C V15.00.00
9.0 11/2013 TD05 Extended by new functions for 8400 HighLine C V14.00.00
8.0 11/2012 TD05 Extended by new functions for 8400 HighLine C V13.00.00 and converted to new
layout.
7.1 09/2012 TD05 Error corrections & supplements
7.0 08/2012 TD05 Extended by new functions for 8400 HighLine C V12.00.00
6.0 10/2011 TD05 Extended by new functions for 8400 HighLine C V11.00.00
5.1 02/2011 TD05 Error corrections & supplements
5.0 11/2010 TD05 Extended by new functions for 8400 HighLine C V06.00.00 and V10.00.00