Lenze 8400 HighLine - Manual (Page 789)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
789
15 Parameter reference
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
15 Parameter reference
This chapter describes all parameters which can be used for parameterising and monitoring the
controller.
Parameters which are only available in the controller from a certain software version onwards are
marked with a corresponding note in the parameter description ("from version xx.xx.xx").
The parameter descriptions are based on software version V15.00.00

Tip!
For quick reference of a parameter with a certain name simply use the index of the online
documentation. The index always contains the corresponding code in parentheses behind
the name.
General information on parameter setting can be found in the chapter "
Introduction:
Parameterising the controller ". ( 26)
For general information on how to read and change parameters, please see the online
documentation for the »Engineer«.