Lenze 8400 HighLine - Manual (Page 1074)

15 Parameter reference
15.2 Parameter list | C01234
1074
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01234
C01235
C01236
Parameter | Name:
C01234 | MCK: Manual jog breakpoints
Data type: INTEGER_32
Index: 23341
d
= 5B2D
h
Breakpoint positions for manual jog
• The drive stops at the parameterised positions if these are located in the manual jog direction and the
approaching of the breakpoints is switched on in C01230 via bit 0.
 Manual jog
Setting range
(min. value | unit | max. value)
-214748.3647 unit 214748.3647
Subcodes Lenze setting Info
C01234/1 0.0000 unit Manual jog: Breakpoint 1
C01234/2 0.0000 unit Manual jog: Breakpoint 2
C01234/3 0.0000 unit Manual jog: Breakpoint 3
C01234/4 0.0000 unit Manual jog: Breakpoint 4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01235 | MCK: Manual jog waiting times
Data type: UNSIGNED_16
Index: 23340
d
= 5B2C
h
Waiting times for manual jog
 Manual jog
Setting range (min. value | unit | max. value)
0.000 s 65.000
Subcodes Lenze setting Info
C01235/1 5.000 s Manual jog: Waiting time 2nd speed
• Time after which the first manual speed ( C01231/1 ) is
accelerated to the second manual speed ( C01231/2 ).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01236 | MCK: Speed follower
Data type: INTEGER_32
Index: 23339
d
= 5B2B
h
Speeds for position follower
 Position follower
Setting range (min. value | unit | max. value)
-214748.3647 units/s 214748.3647
Subcodes Lenze setting Info
C01236/1 360.0000 units/s PosFollower: Sync. speed
• Synchronisation speed for approaching the setpoint
position of the master.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000