Lenze 8400 HighLine - Manual (Page 146)

5 Motor control (MCTRL)
5.2 Selecting the control mode
146
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.2 Selecting the control mode
The 8400 HighLine controller supports various modes for motor control (open loop or closed loop).
• V/f characteristic control (VFCplus) with linear characteristic for asynchronous motors is preset.
• The control mode can be selected in the »Engineer« on the Application parameter tab via the
Motor control ( C00006 ) list field:
• A click on the Motor control... button leads you to the parameterisation dialog of the selected
motor control. (The button is labelled according to the selected motor control.)

Tip!
In order to make the selection of the motor control easier, we provide a selection help with
recommendations and alternatives for standard applications in the subchapter entitled
" Selection help ". ( 150)
The following section briefly describe the control modes. A reference to more details can be found
at the end of each section.