Lenze 8400 HighLine - Manual (Page 76)

3 Commissioning
3.8 Commissioning of the "Table positioning" technology application
76
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.8.4.4 Enter one or more profiles
1. Click the Profile entry button (in the "MotionControlKernel" block) in the signal flow to change
to the Overview  Signal flow  Profile entry dialog level:
2. Select number 3 in the Profile number list field to enter a positioning profile which can be
selected via digital inputs DI5 and DI6.

You can find detailed information on entering profiles in the chapter entitled "Basic drive
functions", subchapter " Profile entry ". ( 579)

Note!
In the Lenze setting, the profiles are assigned to certain operating modes, i.e. the
selection of a profile also results in a change of operating mode:
• If profile 0 is selected: Activation of "Speed follower" operating mode
• If profile 1 is selected: Activation of "Homing" operating mode
• If profile 2 is selected: Activation of "Manual jog" operating mode
• If profile 3 ... 15 is selected: Activation of "Positioning" operating mode