14 parameter change-over – Lenze 8400 HighLine User Manual
Page 779
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
779
14
Parameter change-over
14.1
Configuring parameter change-over via the »Engineer« parameterisation dialog
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3. Click on the
button in order to add the highlighted parameters to the WriteParamList
on the right-hand side.
• With the
and
buttons, you can alter the sequence of parameters in the
WriteParamList.
To remove parameters from the WriteParamList, proceed as follows:
• Highlight the parameter/parameters in the WriteParamList that is/are to be removed
from the WriteParamList.
• Click on the
button to remove the highlighted parameters from the WriteParamList.
4. Click on the OK button to accept the configuration and close the dialog box.
• You can call the configuration dialog again at any time in order to change or expand the
WriteParamList retrospectively.
Changing the values of the definable parameter list
After the compilation of the definable parameter list, the values in the columns 1st value ... 4th
value first correspond to the Lenze setting of the respective parameter.
• Just click one of the input fields in these columns to change the displayed value.
• If you place the cursor in an input field, the permitted value range for the corresponding
parameter is shown under the table.
Changing the values of the motor data parameter list
Click the Motor data parameter list register to put it in the foreground:
• Unlike the "definable" parameter list, the motor data parameter list has a fixed assignment to
the motor and control parameters.
• A list of the switchable motor and control parameters is provided in chapter "
motor data parameter list by means of parameterisation
".
• The preset values are changed in the same way as the definable parameter list.