Lenze 8400 HighLine - Manual (Page 1519)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
1519
17 Function library
17.2 System blocks
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
17.2 System blocks
This chapter describes the system blocks which are available for the controller in the FB Editor.
Overview of system blocks available

The function blocks are described in the chapter " Function blocks ". ( 1233)
System block Function can be inserted into
level:
I/O Appl.
LS_AnalogInput Interface to the analog input terminals
 Analog terminals ( 343)

LS_AnalogOutput Interface to the analog output terminals
 Analog terminals ( 343)

LS_CANManagement Control of internal functions of the CAN driver and display of the
"Operational" status as well as the node address
 System bus "CAN on board" ( 687)
 
LS_DataAccess Lenze internal only 
LS_DeviceMonitor Motor control status signals
 Motor control (MCTRL) ( 131)

LS_DigitalInput Interface to the digital input terminals
 Digital input terminals ( 319)

LS_DigitalOutput Interface to the digital output terminals
 Digital output terminals ( 340)

LS_DisFree Display of 8 arbitrary 16-bit signals of the application on display
codes
 
LS_DisFree_a Display of 8 arbitrary analog signals of the application on display
codes
 
LS_DisFree_b Display of 16 arbitrary digital signals of the application on a bit
coded display code
 
LS_DisFree_p Display of 8 arbitrary position signals of the application on
display codes
 
LS_DriveInterface Interface to drive control (DCTRL)
 Device control (DCTRL) ( 97)

LS_Keypad Control via keypad 
LS_MotionControlKernel Interface to the basic drive function implemented in the Motion
Control Kernel (MCK)
 Basic drive functions (MCK) ( 492)

LS_MotorInterface Interface to motor control (MCTRL)
 Motor control (MCTRL) ( 131)

LS_ParFix
LS_ParFix_2
Output of frequently used constants (TRUE, FALSE, 100 %, etc.) to
be used in the interconnection
• LS_ParFix_2 is available from version 11.00.00.
 
LS_ParFree
LS_ParFree_2
Output of 32 parameterisable 16-bit signals
• LS_ParFree_2 is available from version 11.00.00.
 
LS_ParFree_a
LS_ParFree_a_2
Output of 16 parameterisable analog signals
• LS_ParFree_a_2 is available from version 11.00.00.
 
LS_ParFree_b Output of 32 parameterisable digital signals  
LS_ParFree_p Output of 8 parameterisable position signals  
LS_ParFree_v
LS_ParFree_v_2
Output of 8 parameterisable speed signals
• LS_ParFree_v_2 is available from version 11.00.00.
 