Lenze 8400 HighLine - Manual (Page 423)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
423
7 Technology applications
7.3 TA "actuating drive speed (AC Drive Profile)"
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.3.6 AC Drive Profile diagnostic parameters
In the All parameters tab, the parameters for diagnostic purposes listed in the following table are
displayed in the AC Drive Profile category.
7.3.7 Setting parameters (short overview)

Note!
These parameter are set by the EtherNet/IP™ communication module and should not be
written by the user.
Parameter Info Lenze setting
C01350/1 ACDrive: DriveMode 1: Speed mode
C01351/1 ACDrive: Control word -
C01352/1 ACDrive: Status word -
C01353/1 ACDrive: Speed scaling 0
C01353/2 ACDrive: Torque scaling 0
Highlighted in grey = display parameter
Parameter Info Lenze setting
Value Unit
C00012 Accel. time - main setpoint 2.000 s
C00013 Decel. time - main setpoint 2.000 s
C00019 Auto-DCB: Threshold 3 rpm
C00024 LS_DriveInterface: bNActCompare 0.00 %
C00036 DCB braking: Current 50.00 %
C00039/1 Fixed setpoint 1 40.00 %
C00039/2 Fixed setpoint 2 60.00 %
C00039/3 Fixed setpoint 3 80.00 %
C00039/4...15 Fixed setpoint 4 ... 15 0.00 %
C00101/1...15 Add. accel. time 1 ... 15 0.000 s
C00103/1...15 Add. decel. time 1 ... 15 0.000 s
C00105 Decel. time - quick stop 2.000 s
C00106 Auto-DCB: Hold time 0.500 s
C00107 DCB braking: Hold time 999.000 s
C00134 L_NSet_1: Ramp smoothing 0: Off
C00182 L_NSet_1: S-ramp time PT1 20.00 s
C00190 L_NSet_1: Setpoint arithmetic 0: Out = Set
C00220 L_NSet_1: Acceleration time - add. setpoint 0.000 s
C00221 L_NSet_1: Deceleration time - add. setpoint 0.000 s
C00222 L_PCTRL_1: Vp 1.0
C00223 L_PCTRL_1: Tn 400 ms
C00224 L_PCTRL_1: Kd 0.0