Lenze 8400 HighLine - Manual (Page 662)

9 Diagnostics & error management
9.9 Error messages of the operating system
662
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
dF10: AutoTrip reset [xx.0145.00035]
dF50: Retain error [xx.0145.00050]
dF51: CuCcr error [xx.0145.00051]
dF52: BuCcr error [xx.0145.00052]
Ck01: Pos. HW limit switch [xx.0184.00001]
Response (Lenze setting printed in bold) Setting: C00189 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Too frequent auto-trip reset. • Check the error cause that activates the auto-trip
reset.
• Eliminate error cause and reset (acknowledge) error
manually afterwards.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
An error has occurred when accessing retain data.
• Either caused by an internal hardware error or by lack
of mains switching after a firmware download.
Mains switching
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Mains switching
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Mains switching
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold) Setting: C00595/1 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: The hardware limit switch in positive traversing
direction has tripped.
• The bLimitSwitchPos input for travel range
monitoring via positive hardware limit switch has
been set to FALSE (fail-safe).
Reset error message and retract limit switch.