Lenze 8400 HighLine - Manual (Page 796)

15 Parameter reference
15.2 Parameter list
796
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
15.2 Parameter list
This chapter lists all parameters of the operating system in numerically ascending order.
C00001

Note!
The parameter descriptions are based on the software version V15.00.00.
Parameter | Name:
C00001 | Keypad Userlevel
Data type: UNSIGNED_8
Index: 24574
d
= 5FFE
h
From version 12.00.00 onwards , the extent of menus, submenus and codes shown in the keypad can be adapted by
selecting the "userlevel".
• When the userlevel has been changed, the menus of the keypad will be reconfigured according to the selected
user level.
• Independently of the set userlevel, the parameters of the attached communication module will always be
displayed completely.
Selection list Info
10 Standard Only the most important menus and codes are displayed
on the keypad.
20 Expert All menus and codes are displayed on the keypad.
30 Service Only for servicing purposes (Lenze service).
Subcodes Lenze setting Info
C00001/1 10: Standard Keypad UserLevel
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1