Lenze 8400 HighLine - Manual (Page 1070)

15 Parameter reference
15.2 Parameter list | C01223
1070
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01223
C01224
C01225
Parameter | Name:
C01223 | MCK: Ref. waiting time mode 14/15
Data type: UNSIGNED_16
Index: 23352
d
= 5B38
h
Blocking time for homing modes 14 and 15 (homing towards positive stop)
• The reference is set if an excess of the torque limit set in C01222 has been deteced over a time period defined
here.
 Homing
Setting range
(min. value | unit | max. value)
Lenze setting
0 ms 65000 100 ms
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01224 | MCK: Ref. speeds
Data type: INTEGER_32
Index: 23351
d
= 5B37
h
Speeds for reference search/homing
 Homing
Setting range (min. value | unit | max. value)
0.0000 unit/s 214748.3647
Subcodes Lenze setting Info
C01224/1 720.0000 unit/s MCK: Ref. initial speed
• Start speed for quick approach of the limit
switch/pre-stop mark (depending on the selected
homing mode).
C01224/2 180.0000 unit/s MCK: Ref. search speed
• Search speed for slower - but more precise -
approaching of the touch probe sensor (sensor
reference signal).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01225 | MCK: Ref. accelerations
Data type: INTEGER_32
Index: 23350
d
= 5B36
h
Accelerations for reference search/homing
 Homing
Setting range (min. value | unit | max. value)
0.0000 unit/s2 214748.3647
Subcodes Lenze setting Info
C01225/1 720.0000 unit/s2 MCK: Ref. initial acceleration
• Starting acceleration for the starting speed ramps.
C01225/2 720.0000 unit/s2 MCK: Ref. search acceleration
• Search acceleration for the search speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000