Konica Minolta bizhub PRESS C8000e - Manual (Page 407)

bizhub PRESS C8000/e 9-89
9.12 [05 Color Density Control] 9
7
For the automatic adjustment selected in step 4, select either [Yes] or [No] for [Adjustment While Job
Running].
% Select [Yes] to make the adjustment during a job operation, or select [No] to wait. Selecting [No] will
not make the adjustment even when specified interval is past, but make it before the next job starts.
8
For the automatic adjustment selected in step 4, select either [Yes] or [No] for [Link to Quality Adjust-
ment].
Selecting [Yes] will set the machine to automatically operate the color density control after [Gamma
Correction] functions when specified from [02/03 Administrator Setting] - [01 System Setting] - [04/05
Expert Adjustment] - [04/07 Quality Adjustment] - [02/04 Stabilization Adj. Setting] on the Utility Menu
Screen.
9
Press [OK] to restore the Color Density Control Menu Screen.
9.12.2 [02 Color Density Manual Control]
This section describes how to operate the gamma correction manually (referred to as the color density man-
ual control hereafter), using the sensor attached to Relay Unit RU-508.
- The Color Density Manual Control allows you to make the adjustment individually for each of predefined
screen types. [Auto] is unavailable for the adjustment.
- Select the desired paper type in the procedure of manual adjustment.
- Select either default colorimetric data or custom colorimetric data registered by creating a paper cate-
gory, in order to use them as the base data in the adjustment.
- The number of sheets output as charts are included in the print count.
- With [Yes] specified for Use Color Density Control, this manual adjustment is requisite and should be
performed before any job operation.