Konica Minolta bizhub PRESS C8000e - Manual (Page 348)

9.5 [03 Finisher Adjustment] (Folding Unit FD-503) 9
bizhub PRESS C8000/e 9-30
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [03 Multi Folder (Fold) Adj.], and [01 Half-Fold Position Adj.] in se-
quence.
The Half-Fold Position Adjustment Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Measure the misalignment (a) between the edges of output sheet.
Allowance: a = 0 +/- 1.5 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the Half-Fold Position Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 (Short) to +50 (Long) (1 step = 0.1 mm)
% The measurement (a) in step 7 will decrease with positive value entered, and increase with negative
value entered.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Multi Folder (Fold) Adjustment Menu Screen.
9.5.4 [03 Multi Folder (Fold) Adj.] - [02 Tri-Fold-in Pos. Adj.]
Adjust the folded positions in Tri-Fold-in mode determined by Folding Unit FD-503.
Objects of adjustment: Full Area, A3 w, B4 w, SRA4 w, A4 w, 12 e 18 w, 11 e 17 w, 8.5 e 14 w, 8.5 e 11 w,
8K w, Custom (380-458 mm), Custom (279-379 mm)
NOTICE
When adjusting both Single Fold and Double Fold, be sure to start with the Double Fold adjustment. The po-
sition of Single Fold is calculated from the edge of the sheet, while that of Double Fold is calculated from the
position of Single Fold. Consequently, the measurement (b) in step 7 is subject to the change in either position
of the fold.
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].