Konica Minolta bizhub PRESS C8000e - Manual (Page 376)

9.8 [03 Finisher Adjustment] (Perfect Binder PB-503) 9
bizhub PRESS C8000/e 9-58
12
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -128 (Soon) to +127 (Late) (1 step = 0.1 mm)
% If desired, display the help message to view details of the adjustment you made.
13
Repeat the steps from 6 to 12 until the desired result is obtained.
14
Press [Return] to restore the Perfect Binder Adjustment Menu Screen.
9.8.6 [07 Perfect Binder Adjustment] - [06 Temperature Adjustment]
Control the condition of glue to be dried by setting temperature on the sensors inside the melt tank and of
the glue apply roller using Perfect Binder PB-503.
The following four types of sensors are provided.
Glue Tank -Top:
The machine supplies glue pellets on detecting the temperature of solution surface lower than the set point.
It is recommended to be set higher in thermal environment where the machine tends to fail in detection.
Initial: 132°C, Recommended: 128 to 136°C
Glue Tank -Mid:
Set the temperature to reach when warm-up is completed, and to start rotating the roller. Setting it higher
helps glue temperature to be stable sooner.
Initial: 145°C, Recommended: 140 to 145°C
Contact your service representative for setting change in Glue Tank - Top and Glue Tank - Mid is desired.
Glue Tank -Low:
Adjust the temperature to control the tank heater.
Low temperature: increases glue viscosity High temperature: decreases glue viscosity
Initial: 185°C
Recommended: 180 to 190°C
Glue Apply Roller:
Adjust the temperature to control the roller heater. This also supports heating of the glue.
Low temperature: increases glue viscosity High temperature: decreases glue viscosity
Initial: 165°C
Recommended: 160 to 170°C
NOTICE
Do not make unnecessary change in the temperature setting of sensors inside the melt tank.