Konica Minolta bizhub PRESS C8000e - Manual (Page 389)

bizhub PRESS C8000/e 9-71
9.9 [03 Finisher Adjustment] (Finisher FS-612) 9
7
Check the amount of staple pitch.
8
If any adjustment is required, press [Exit Print Mode] to return to the 2 Position Staple Pitch Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: +128 to +160 (1 step = 1 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Finisher Adjustment Menu Screen.
9.9.9 [06 Post Inserter Tray Size]
Adjust the tray size of post inserter if needed, when using Finisher FS-612.
Objects of adjustment: A4 w, 8.5 e 11 w
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment] and [06 Post Inserter Tray Size] in sequence.
3
Use [Next] and [Previous] to select either PI 1 Tray or PI 2 Tray.
4
Load the specified paper size into the post inserter tray to be adjusted, then press the Start/Stop but-
ton of the post inserter.
5
Press [Return] to restore the Finisher Adjustment Menu Screen.