Konica Minolta bizhub PRESS C8000e - Manual (Page 334)

9.2 [01 Machine Adjustment] 9
bizhub PRESS C8000/e 9-16
5
Load A3 w paper into the tray to be adjusted, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Measure the resultant magnification in the direction perpendicular to the paper feed direction.
Allowance: +/- 0.5% or less
Within 190 +/- 1 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the CD-Mag. Adjustment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -100 (Short) to +100 (Long) (1 step = 0.1 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Printer Adjustment Menu Screen.
9.2.5 [02 Scan Adjustment] - [01 Restart Timing Adjustment]
Adjust the position to start scanning when using the original glass to scan the original.
NOTICE
Make this adjustment after completing [03 FD-Mag. Adjustment].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [01 Machine Adjustment], [02 Scan Adjustment], and [01 Restart Timing Adjustment] in sequence.
The Restart Timing Adjustment Screen will be displayed.
3
Press [Print Mode].
4
Load A3 w paper into a tray, then select that tray key.
5
Place the test chart on the original glass, then press Start on the control panel. A sample pattern will
be output.