Konica Minolta bizhub PRESS C8000e - Manual (Page 377)

bizhub PRESS C8000/e 9-59
9.8 [03 Finisher Adjustment] (Perfect Binder PB-503) 9
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [07 Perfect Binder Adjustment], and [06 Temperature Adjustment] in se-
quence.
The Temperature Adjustment Screen will be displayed.
3
Load cover sheets in either cover tray of perfect binder or any other tray.
4
Load paper for body sets in the desired tray.
5
Press the key of the item to be adjusted.
6
Press [Print Mode].
7
Select the tray key loaded with paper for body sets.
8
Press Start on the control panel. A sample pattern of perfect-bound book will be output.
9
Check that the glue applied on the body set is in proper condition.
10
If any adjustment is required, press [Exit Print Mode] to return to the Temperature Adjustment Screen.
11
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
12
Repeat the steps from 6 to 11 until the desired result is obtained.
13
Press [Return] to restore the Perfect Binder Adjustment Menu Screen.
9.8.7 [07 Perfect Binder Adjustment] - [07 Sub Compile CD Width Adj.]
Change the adjustment width if output sheets cannot be aligned in sub compile section using Perfect Binder
PB-503. The sizes referred to in this section are those of body sets corresponding to cover sizes.
Objects of adjustment: Full Area, A4 v, B5 v, A5 w/v, 8.5 e 11 v, 5.5 e 8.5 w, 16K v, Custom (220-379 mm),
Custom (148-219 mm)
NOTICE
Use this adjustment if the former half of body pages is misaligned when making more than one perfect-bound
book. If misalignment appears on the latter half of body pages, use [07 Perfect Binder Adjustment] - [08 Clamp
CD Width Adjustment].
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.