Konica Minolta bizhub PRESS C8000e - Manual (Page 385)

bizhub PRESS C8000/e 9-67
9.9 [03 Finisher Adjustment] (Finisher FS-612) 9
11
Press [Return] to restore the Punch Adjustment Menu Screen.
9.9.4 [03 Punch Adjustment] - [02 Horizontal Position Adj.]
Adjust the distance from the edge of the output sheet to the center of punch holes if needed, when using
Finisher FS-612.
Objects of adjustment: PI Tray, Main Body Tray
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [03 Punch Adjustment], and [02 Horizontal Position Adj.] in sequence.
The Horizontal Position Adjustment Screen will be displayed.
3
Select either [PI Tray] or [Main Body Tray].
4
Press [Print Mode].
5
Select the tray loaded with paper.
6
Press Start on the control panel. A sample pattern will be output.
7
Measure the distance (a) from the edge of the output sheet to the center of punch holes.
Allowance: a = 10.5 +/- 5.0 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the Horizontal Position Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 (Wide) to +50 (Narrow) (1 step = 0.1 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.