Konica Minolta bizhub PRESS C8000e User Manual
Page 342
9.4
[03 Finisher Adjustment] (Finisher FS-521)
9
bizhub PRESS C8000/e
9-24
NOTICE
This adjustment is effective against the paper with a width in horizontal scanning direction of 182 mm (B5
w
)
or more in straight delivery, or 210 mm (A4
w
) or more in shift delivery. Small sizes such as A5
w
, B6
w
, or
5.5
e
8.5
w
are unavailable because adjustment guides will not operate for those small sizes.
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [01 Staple Finisher Adjustment], and [04 Exit Guide Center Pos. Adj.] in
sequence.
The Exit Guide Center Position Adjustment Screen will be displayed.
3
Press the desired key to select the condition for adjusting the center position of exit guides.
[Straight (Small)]: Using small sizes (182 mm or more in length, 297 mm or less in width) in straight de-
livery
[Straight (Large)]: Using large sizes (182 mm or more in length, 298 mm or more in width) in straight
delivery
[Shift Front (Small)]: Using small sizes (210 mm or more in length, 297 mm or less in width) offset to the
front in shift delivery
[Shift Front (Large)]: Using large sizes (210 mm or more in length, 298 mm or more in width) offset to
the front in shift delivery
[Shift Back (Small)]: Using small sizes (210 mm or more in length, 297 mm or less in width) offset to the
back in shift delivery
[Shift Back (Large)]: Using large sizes (210 mm or more in length, 298 mm or more in width) offset to
the back in shift delivery
Small/Large sizes used in straight delivery are not exactly the same as those used in shift delivery
(front/back). Classifications of standard sizes are as follows.
Straight (Small): A4 w/v, B5 w/v, A5 v, 8.5 e 11w/v, 5.5 e 8.5 v
Straight (Large): A3 w, B4 w, 12 e 18 w, 11 e 17 w, Foolscap
Shift Front/Back (Small): A4 w/v, B5 v, 8.5 e 11 w/v, 5.5 e 8.5 v
Shift Front/Back (Large): A3 w, B4 w, 12 e 18 w, 11 e 17 w, Foolscap
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.