Konica Minolta bizhub PRESS C8000e - Manual (Page 360)

9.7 [03 Finisher Adjustment] (Saddle Stitcher SD-506) 9
bizhub PRESS C8000/e 9-42
9.7 [03 Finisher Adjustment] (Saddle Stitcher SD-506)
9.7.1 [06 Saddle Stitcher Pos. Adj.] - [01 Staple Center Position]
Adjust the center position of staples determined by Saddle Stitcher SD-506.
NOTICE
Make this adjustment after completing [01 Staple Finisher Adjustment] - [02 Paper Width Adj. (Staple)].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [06 Saddle Stitcher Pos. Adj.], and [01 Staple Center Position] in se-
quence.
The Staple Center Position Adjustment Screen will be displayed.
3
Press [Print Mode].
4
Load the desired paper size into a tray, then select that tray key.
5
Press Start on the control panel. A sample pattern will be output.
6
Measure the difference (a) between the center line and center position of staples.
Allowance: a = 0 +/- 2 mm
7
If any adjustment is required, press [Exit Print Mode] to return to the Staple Center Position Adjustment
Screen.
8
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 (Leftward) to +20 (Rightward) (1 step = 0.1 mm)
9
Repeat the steps from 3 to 8 until the desired result is obtained.
[1] Center position of staples [2] Center line of paper