Konica Minolta bizhub PRESS C8000e - Manual (Page 392)

9.10 [03 Finisher Adjustment] (Relay Unit RU-506) 9
bizhub PRESS C8000/e 9-74
9.10.2 [01 Relay Stacker Adjustment] - [02 Paper Length Adjustment]
Adjust the position of the front stopper if punch holes show misalignment in paper feed direction when using
Relay Unit RU-506.
Object of adjustment: 8.5 e 11 v
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [08 Relay Stacker Adjustment], and [02 Paper Length Adjustment] in se-
quence.
3
Press [Print Mode].
4
Select the tray key loaded with 8.5 e 11 v paper.
5
Press Start on the control panel. A punched sample pattern will be output.
6
Check the position of punch holes.
% If punch holes show misalignment in paper feed direction, the position of the front stopper needs to
be adjusted.
7
If any adjustment is required, press [Exit Print Mode] to return to the Paper Length Adjustment Screen.
8
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 to +50 (1 step = 0.1 mm)
9
Repeat the steps from 3 to 8 until the desired result is obtained.
10
Press [Return] to restore the Relay Stacker Adjustment Menu Screen.