Konica Minolta bizhub PRESS C8000e - Manual (Page 359)

bizhub PRESS C8000/e 9-41
9.6 [03 Finisher Adjustment] (Large Capacity Stacker LS-505) 9
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [05 Stacker Adjustment], and [02 Paper Length Adjustment] in se-
quence.
The Paper Length Adjustment Screen will be displayed.
3
If two units of Large Capacity Stacker LS-505 are connected, select either [Stacker No. 1] or [Stacker
No. 2].
4
Press [Print Mode].
5
Load the desired paper size into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment (a) in the sheets delivered to the stacker.
8
If any adjustment is required, press [Exit Print Mode] to return to the Paper Length Adjustment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 (Opposite direction) to +20 (Paper feed direction) (1 step = 0.1 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Stacker Adjustment Menu Screen.