Konica Minolta bizhub PRESS C8000e - Manual (Page 184)

5.3 Both Sides Adjust 5
bizhub PRESS C8000/e 5-44
13
Measure the misalignment between + marks [1] to [4] on the back side (having [back] printed) and the
same marks on the front side (having [front] printed) of the output chart.
% The gray + mark in the figure below represents the one on the front side, and the black + mark on
the back side.
% Using a scale, measure the horizontal (X-axis) and vertical (Y-axis) misalignments in each print po-
sition. You can measure and enter the value in 0.1 mm increments.
% As shown in the figure below, if the + mark [1] on the back side is misaligned rightward by 0.5 mm
and downward by 0.3 mm from that on the front side, the print position [1] needs to be corrected
by +0.5 mm and +0.3 mm in the X direction and Y direction, respectively.
% Be sure to make note of the measured values including a plus or minus sign.
14
Press [X] or [Y] of the points from [1] to [4], and then enter the measured value using the touch panel
keypad or control panel keypad.
% You can change the value by pressing [,] and [+].
% Use [+/-] to specify the value to be positive or negative. If the + mark on the back side is misaligned
rightward or downward, select the plus sign. If it is misaligned leftward or upward, select the minus
sign.
% Press [Clear] to reset the entered value to [0].
15
When completing the entry, press [Adjustment Start].
% If you do not start the adjustment, press [Close].
% Pressing either [Adjustment Start] or [Close] clears the entered value to [+0.0].
The Both Sides Adjust Screen will be restored.
16
When the Chart Adjustment is completed, press [Close].
The Machine Screen will be restored.
back