Konica Minolta bizhub PRESS C8000e - Manual (Page 211)

bizhub PRESS C8000/e 5-71
5.10 Using Perfect Binder PB-503 5
5.10 Using Perfect Binder PB-503
5.10.1 Turning On/Off the Heater of the Perfect Binder
The Perfect Binder PB-503 has an inner heater to add heat to glue pellets for making perfect-bound books.
It requires approximately 20 minutes of warmup time to melt the pellets to be ready for the operation.
Adding heat continuously to glue pellets, however, may deteriorate them if the Perfect Binder PB-503 is kept
unoperated.
To prevent the deterioration of glue pellets, the heater of the perfect binder is designed to be turned off au-
tomatically in the following condition.
- One minute after a perfect binding job is completed
- One minute after completion of the warmup if any operation has not been made on the perfect binder
To turn on the heater of the perfect binder
Turning on the sub power switch of the main body does not turn on the heater of the perfect binder at the
same time to start warming up automatically.
The heater of the perfect binder automatically starts warming up when [Perfect Bind] is selected on the Out-
put Setting Screen, or when a print job using perfect binder is received.
If you know the time to use the Perfect Binder PB-503 in advance, calculate the timing to turn on the heater
with required warmup time, then manually turn it on by pressing the inner heater switch for the perfect binder
[ON] on the Machine Screen.
%
Press [ON] for the inner heater switch for the perfect binder provided on the Machine Screen to start
the heater of the perfect binder warming up. The message right to the inner heater switch for the perfect
binder is changed to [PB Shut Off] to [PB Warming Up].