Konica Minolta bizhub PRESS C8000e - Manual (Page 345)

bizhub PRESS C8000/e 9-27
9.5 [03 Finisher Adjustment] (Folding Unit FD-503) 9
9.5 [03 Finisher Adjustment] (Folding Unit FD-503)
9.5.1 [02 Multi Folder (Punch) Adj.] - [01 Paper Width Adjustment]
Adjust the width of adjustment plates for a specific paper size if punch holes made by the Folding Unit FD-
503 dislocate largely.
Objects of adjustment: Full Area, A3 w, B4 w, SRA4 w, A4 w/v, B5 w/v, A5 w/v, 12 e 18 w, 11 e 17 w,
8.5 e 14 w, 8.5 e 11 w/v, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K w/v, 9 e 11 v
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [02 Multi Folder (Punch) Adj.], and [01 Paper Width Adjustment] in se-
quence.
The Paper Width Adjustment Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Set the print quantity to 10, then press Start on the control panel. A sample pattern will be output.
7
Check the diameter of holes penetrating through piled output sets.
% Check if the punch holes show misalignment (a) (caused if the width of adjustment plates is larger
than the paper width), or are curved (b) (caused if the width of adjustment plates is smaller than the
paper width).
Number of punch holes Allowance
2 holes 5.0 mm or more in diameter
4 holes 6.5 mm or more in diameter