Konica Minolta bizhub PRESS C8000e - Manual (Page 293)

bizhub PRESS C8000/e 8-15
8.4 If Burrs Remain in Punch Holes: Multi Punch GP-501 8
8.4 If Burrs Remain in Punch Holes: Multi Punch GP-501
If you find burrs remaining in punch holes when using Multi Punch GP-501, lubrication is required for the die
set currently used.
Lubricate it at the position illustrated below.
NOTICE
Never use the oil on the general market. For the oil to be used in this procedure, please contact your service
representative.
If burrs still remain in punch holes after the lubrication, apply grease to the positions illustrated below.
NOTICE
Never use the grease on the general market. For the grease to be used in this procedure, please contact your
service representative.