Konica Minolta bizhub PRESS C8000e - Manual (Page 179)

bizhub PRESS C8000/e 5-39
5.3 Both Sides Adjust 5
8
Press [Exit Print Mode], and then press [Close].
9
Check whether or not the printed chart has been fed skewed or wrinkled.
10
If the paper has skewed print or wrinkles, press [Registration Loop].
11
Enter an adjustment value using the touch panel keypad or control panel keypad.
% Adjustment range: -99 (to make loop smaller) to +99 (to make loop larger) (1 step = 0.1 mm)
% If the paper is skewed, make the loop larger. If the paper is wrinkled, make the loop smaller.
% Use [+/-] to specify the value to be positive or negative.
% Press [Clear] to reset the entered value to [0].
% You can also change the value by pressing [,] and [+].
12
Repeat the steps from 5 to 11 until the desired result is obtained.
13
Press the [Back] tab to adjust the amount of registration loop for the back side.