Konica Minolta bizhub PRESS C8000e - Manual (Page 116)

3.4 Using Machine When Power Save LED Lights 3
bizhub PRESS C8000/e 3-52
3.4.4 Manually Conserving Energy
Follow the procedure below to operate Power Save function (Low Power or Shut Off) manually.
1
Hold down Power Save on the control panel for over a sec-
ond.
The following message will be displayed.
Using Shut Off mode:
[Entry shut off mode, after 10 sec. / Press key/screen to cancel]
Using Low Power mode:
[Entry low power mode, after 10 sec. / Press key/screen to can-
cel]
2
Power Save will be activated.
The Power Save LED lights and the touch panel goes off.
Be sure to hold down Power Save on the control panel for over a second, otherwise Power Save will
not be activated with the following message displayed.
[Keep [Power Save] pressed more than one second to enter auto shut off]
[Keep [Power Save] pressed more than one second to enter auto low power]
d
Reference
The machine is initially set to activate the Shut Off mode manually. The Utility Menu Screen allows you to man-
ually activate the Low Power mode instead. See page 10-49 for details.
3.4.5 Limiting Machine Usage: Weekly Timer
Weekly Timer turns a machine on and off at the time specified by the administrator.
When a machine is in OFF condition under control of Weekly Timer, the Power Save LED is lit and machine
operation is unavailable.
d
Reference
Weekly Timer settings are provided on the Utility Menu Screen. See page 10-62 for details.
To use the machine temporarily
The following procedure temporarily enables the machine operation. (Timer Interrupt)
1
Press Power Save on the control panel.
The Machine Screen will be displayed along with the message shown below.
[Weekly timer is temporarily canceled / Please enter password $###]
[Please enter desired copy time / 0 hour(s) 05 minute(s)]
If the above message is displayed, proceed to step 3.
% The machine power will be turned off automatically after 5 minutes from this state without any op-
eration made.
2
Enter the Timer Interrupt password, then press Start on the control panel.
Enter a 4-digit Timer Interrupt password using the control panel keypad, then press Start.
[Weekly timer is temporarily canceled / Please enter password $###]
% The Timer Interrupt password is to be specified on the Utility Menu Screen. Ask your administrator
for the password.
% If an invalid password is entered, continue by entering the valid 4-digit password.
3
Set the hour for the interrupt use, then press Start on the control panel.
Enter a 1-digit hour (from 0 to 9) using the control panel keypad, then press Start.
[Please enter desired copy time / 3 hour(s) 05 minute(s)]