Allied Telesis AT-S60 - Manual (Page 78)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 77
Do you want to delete Trap Receiver IP Address?
14. Enter Y to delete the IP address of the Trap Receiver. Enter N to retain
the IP address of the Trap Receiver. Press Return.
15. Select 3 - Set Community Access Mode to change the access mode
from read only to read/write or vice versa. Follow the prompts.
16. Select 4 - Set Community Status to enable or disable the current
community. Follow the prompts.
17. Select 5 - Set Community Open Access to allow access to an SNMP
community.
Chose of the following options:
Y - Allows access to this community by any management station
N - Allows access to this community by the management stations
configured within this community.
Follow the prompts.
18. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Changes to the SNMP parameters are immediately activated on
the switch.