Allied Telesis AT-S60 - Manual (Page 485)

Chapter 31: Port Trunking
Section IV: Web Browser Management 484
10. Configure the ports on the remote switch for port trunking.
You can now connect the data cables to the ports of the trunk on
the switch.
Deleting a Port
Trunk
To delete a port trunk, perform the following procedure:
Caution
Before you delete a trunk in software, disconnect the cables from
the ports. Deleting the trunk without disconnecting the data cables
can create a loop in your network topology. This situation can result
in broadcast storms.
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. From Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab shown by
default, as shown in Figure 168 on page 466.
3. Select the Port Trunking tab.
The Port Trunking tab is displayed as shown in Figure 175 on page
482.
4. Select a trunk.
A green light appears next to the selected trunk.
5. Click Remove.
The port is deleted from the switch. The Port Trunking page is
updated to reflect your changes.
To save your changes, return to the General tab and click Save
Changes. Your changes are saved on the switch.