Allied Telesis AT-S60 - Manual (Page 264)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 263
After you have entered the tagged ports of the VLAN, the following
prompt is displayed:
Enter Untagged Port-list:
8. Specify the ports on the switch to function as untagged ports in the
VLAN.
If this VLAN does not contain any untagged ports, leave this field
empty. For information on entering ports, refer to Specifying Ports
on page 31.
After you have specified the untagged ports, the management
software automatically creates the VLAN. The Configure Port Based
VLAN Menu (Figure 95 on page 261) is updated with your new VLAN.
9. Check to see that the VLAN was created correctly and that it contains
the appropriate ports.
The new VLAN is now ready for use.
Note
Ports designated as untagged ports of a new VLAN are
automatically removed from their current untagged VLAN
assignment. For example, if you are creating a new VLAN on a switch
that contains only the Default_VLAN, the ports that you specify as
untagged ports of the new VLAN are automatically removed from
the Default_VLAN when the new VLAN is created.
Tagged ports are not removed from any current VLAN assignments
because tagged ports can belong to more than one VLAN at a time.
10. Repeat this procedure starting with Step 4 to create additional VLANs.
11. After making changes, type R to return to the Main Menu. Then type
S to select Save Configuration Changes.