Allied Telesis AT-S60 - Manual (Page 75)

Chapter 4: SNMP Community Strings
Section II: Local and Telnet Management 74
Deleting a SNMP Community
Use the following procedure to delete a SNMP community.
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 47.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 9 on page 52.
3. From the Configure System Menu, type 1 - Configure System
Software.
The Configure System Menu is shown in Figure 10 on page 53.
4. From the Configure System Software Menu, type 8 - Configure SNMP.
The Configure SNMP Menu is shown in Figure 17 on page 70.
5. Select 3 - Configure SNMP Community to configure SNMP
parameters.
The Configure SNMP Community menu is shown in Figure 18 on
page 71.
6. Select 2 - Delete SNMP Community to remove an SNMP community.
The following prompt appears:
Enter SNMP Community Name:
7. Enter a SNMP community name from the list at the top of the menu.
Press return.
A confirmation message is displayed.
8. Enter Y to delete the SNMP community.
The display at the top of the Configure SNMP Community menu is
updated to reflect your changes.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Changes to the SNMP parameters are immediately activated on
the switch.