Allied Telesis AT-S60 - Manual (Page 557)

Chapter 38: TACACS+ and RADIUS Protocols
Section IV: Web Browser Management 556
Enabling TACACS+ or RADIUS
To configure the authentication protocols, perform the following
procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 212.
Figure 212 Configuration System Page, Server-based Authentication Tab
3. To enable or disable the authentication feature on the switch, click
the Enable Server-based Authentication check box. A check in the
box indicates that this feature is disabled. No check indicate the
feature is enabled. The default is disabled.