Allied Telesis AT-S60 - Manual (Page 503)

Chapter 33: STP, RSTP, and MSTP
Section IV: Web Browser Management 502
Configuring RSTP
To configure RSTP, perform the following procedure:
Caution
The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. Consult the IEEE 802.1w standard before changing
any of the RSTP parameters.
1. Follow the steps in the procedure described in Enabling STP, RSTP,
or MSTP on page 496.
2. On the Spanning Tree tab, click Configure.
3. Select RSTP as your active protocol version.
The Configure RSTP Parameters tab is displayed as shown in
Figure 186.